Installation and Car Seat Safety
A recent study conducted at the Oregon Health and Science University Hospital showed that 93 percent of parents taking newborns home from the hospital had made at least 1 critical error when installing their car seat (a "critical error" was defined as an error that could lead to injury or death in the event of an accident).
An earlier study by the National Highway Transportation Safety Administration (NHTSA) found that 84% of infant seats exhibited critical misuse, either in installation of the seat or improper restraint of the infant.
The 9 Most Common Car Seat Mistakes to Avoid
This list of common installation and harnessing mistakes is based on findings from the OSHU study of parents taking newborn infants home from the hospital, in order of most common.
#1. Harness too loose (69%)
The most common mistake made by parents of a newborn is leaving the harness too loose. Follow your car seat's instructions carefully to learn how to properly tighten your harness. Make sure it is tight enough to pass the "pinch test"; the harness is tight enough when you cannot pinch any extra harness material between your fingers and thumb at the shoulder.
#2. Car safety seat installed too loosely (43%)
The car seat base should be tightly enough installed that it can only move an inch or less in any direction. Watch this video for tips on installing the base with LATCH, or this one for installing the base with the seat belt.
#3. Recline angle of car safety seat incorrect (36%)
Your car seat will have some kind of level gauge or line to help you make sure the angle of the base is properly leveled. Look in your car seat manual for instructions on how to make it properly leveled.
#4. Retainer clip too low (34%)
The retainer clip should be placed at armpit level. When it is too low there is risk your baby will not be properly restrained in the event of an accident and may suffer dangerous injury to the abdomen and internal organs.
#5. Safety belt used but not locked (23%)
Installing the base with a seat belt is more challenging, and while it is perfectly safe when properly, we recommend using LATCH anchors due to the increased simplicity and ease-of-installation. If you do choose to install the base using a seat belt, we encourage you to choose one of the car seats that is relatively easy to install using a seat belt. Whe properly installed, you should not be able to move the base more than 1 inch in any direction. We'd also encourage you to visit your local car seat inspection station, and have them check out your seat installation, in your car, before your baby is born. Visiting a car seat inspection station is a good idea in any case, but especially important if you are installing the base using the seat belt. The video below from The Car Seat Lady can help augment reading your car seat and vehicle owners manual, and having your seat belt installation checked at an inspection station:
#6. Use of after-market product not approved with seat (20%)
Avoid the use of add-on products or accessories with your car seat, unless your car seat manual approves their use. Car seats undergo extensive testing, and you may create an untested configuration by using an after-market product with the seat.
#7. Harness too high (18%)
Each seat will have its own way of adjusting the harness height. It is important that the height of the harness be adjusted so it exits the back of the seat at or below your baby's shoulder height. Read your car seat manual for specifics on how to adjust it, and what height it should be at for your baby.
#8. Incorrect spacing between car safety seat and vehicle front seat (17%)
The front seat position should be set so that it will not interfere with the child restraint system. Leave a significant space between the front seat and the car seat, keeping in mind that the seat may move up to an inch based on normal tightness of the straps, and in the event of an accident, the straps may stretch a bit more. Leaving a clear and free space between the carrier and the front seat makes it easier to be certain the car seat carrier is firmly clicked-into and locked into the base, and allows the child restraint system to properly operate in the event of an accident. Be sure to check your car seat and vehicle owners manual to learn the exact spacing your seat requires.
#9. Caregiver not knowing how to adjust the harness (15%)
It is important that anyone who will act as a caregiver for your infant knows how to properly use the car seat, and how to properly harness your baby into the seat. Like many baby products, such as monitors and bottle warmers, you'll need to make sure that it is not just you who can operate them correctly, but grandparents and baby sitters too.
Helpful Car Seat Installation Tips
Here's a few simple and easy tips to keep in mind. First off, take a look at this video below produced by the National Child Passenger Safety board. While a bit dry, it is informative and covers both installation with the seat belt and with LATCH anchors:
Buy an Easy-to-Install and Use Car Seat
We believe that such common frequency of mistakes when installing or using a car seats should impact what car seat you ultimately decide buy. Those seats that are easier to install and use have a real safety advantage. You'll see that in our comprehensive Infant Car Seat Review we have gone to great lengths to examine ease-of-installation and ease-of-use as much as we examine crash test data.
Visit Your Local Car Seat Inspection Station
One thing we urge all readers to seek out, once you've purchased your car seat, is your local car seat inspection station. You can locate a car seat installation check station near you by simply entering your Zip code on the Safer Car website. Typically located at places like your local fire station or police station, car seat inspection locations are staffed by certified Child Passenger Safety Technicians who can help you learn how to properly install your car seat (or just confirm that you've done it right), in your car, and help assure your baby's safety. It is free, and a great national resource. Take advantage of it.
Read the Manual
The high-percentage of improperly installed car seats and/or restrained infants make it crystal clear that it is really easy to make mistakes when installing a car seat, placing a carrier on the base, or adjusting the harness around baby. We think parents might be prone to making honest mistakes and potential errors when they are in a rush, feeling emotional, or are tired; which is pretty much how new parents feel every day.
We encourage you to take this matter seriously and plan a little extra time for installing and buckling baby in properly every time you use the car seat. In addition, we suggest ALL parents take their new car seat and car to a checkpoint station before baby is born to learn the ins and outs of proper car seat installation. The experts can help you determine the exact right location and installation options for your specific seat and vehicle. This takes the guesswork out of the process and allows parents to feel confident in their seat installation. Parents should avoid moving the base after the technician installs it and should consider purchasing a second base if they plan to use the car seat in more than one car. The fewer steps parents have to manage each time baby goes for a ride, the fewer opportunities parents have to make a mistake.